Wavlink AC600 is a networking device used to uplift network signals. If you are using the wireless network and facing trouble in your existing network like connection dropout, no signal in a particular area, weak signal etc. then you can use this device. The device will not only extend internet signals but also enhance the security of the network. Setting up wavlink AC600 is not a daunting process if you are aware of it. This page is especially created to guide you about the Wavlink Ac600 Setup process. Further you will find step by step setup process along with other important information. So, read the content till the end.
Wavlink AC600 Setup Process
Setting up wavlink AC600 can be done using web & WPS. Both setup methods are easy to follow. You can choose either method to perform setup. WPS method is less time consuming whereas web based setup allows you to perform several customizations in the network. Look over the steps you need to follow in both the methods.
WPS Based Setup
WPS based setup is a push button setup method. To configure your device using this method requires a host networking device enabled WPS. Check out the whole setup process further:
- Firstly decide the placement of the wavlink AC600.
- Thereafter step ahead and connect it with power.
- Let the booting process complete. It might take around 5 minutes.
- Once done, push the WPS button and hold it for 10 seconds.
- Next you have to push the WPS button of host network device
- Hold it for 10 seconds before release.
- Wait and monitor the device to complete the Wavlink AC600 Setup process.
- Once setup is complete you can relocate the wavlink ac600.
Web Based Setup
Web based setup method requires a laptop/ computer along with a host networking device with working internet, an ethernet cable and power outlet. Check out the whole setup process further:
- Firstly confirm where to place the wavlink AC600.
- Thereafter connect it with power using power adapter & cable.
- Let the booting process complete. It might take around 5 minutes.
- Once done, you need to connect your computer/ laptop device with the wavlink network.
- After getting the access of LAN network of devices, initiate the setup by launching a web browser.
- Mention the IP address or web address to get the access of settings.
- Initiate the Wavlink AC600 Setup by using the default login information.
- Connect the device with the host network and create SSID & Password for security.
- Make other changes and save them by choosing the save option.
- Finalize the setup by choosing the “finish” option.
- Relocate it for optimal performance & test the new network.
Conclusion
From the crux of the above description we would like to conclude that the wavlink ac600 setup is not a difficult process. Anyone can do it with no technical expertise. It’s just a matter of knowledge. With the adequate information you can do it by yourself. Still if you get stuck while performing setup then call us on a given number. Our team will help you.