Eliminate Connectivity Issues With Wavlink Repeater Setup

Wavlink offers a vast variety of wifi repeaters. These repeaters effectively eliminate all the dead zones as well as various other connectivity issues. After its successful installation you get high speed wifi connectivity all around your home. But to utilize the device to its full potential it’s important to perform the right 192.168.10.1 wifi repeater setup process. The steps for the same are extremely easy and straightforward therefore one can perform it without any expert assistance. 

Requirements For 192.168.10.1 Wifi Repeater Setup

For the setup there are few requirements that are as follows:

• First and most important you need a router with an active internet plan.
• Thereafter an ethernet wire for establishing a connection between the smart gadget and the Wavlink wifi repeater (optional).
• Next a smart device which can be your smartphone, laptop, computer or an iPad.
• A vacant and properly working power outlet nearby to the host router. 
• Additionally you require details of your existing wifi network like its username and security key (password). 
• Lastly, for conducting a smooth 192.168.10.1 wifi repeater setup, note down the default network details from the extender’s product label which is pasted on one of the panels of the repeater. 

Note: In case you tried performing the 192.168.10.1 wifi repeater setup earlier, but couldn’t complete it successfully, then first reset the extender to factory settings. As it will allow you to conduct a fresh setup. 

Setup Guidance 

Begin the process by first placing the Wavlink repeater in the same area as your host router. This proximity is important only during the initial setup. 

Thereafter with the help of a power adapter, activate the extender. Wait until the power LED turns on properly. This may take up to a few seconds or minutes so meanwhile be patient. 

In this step of 192.168.10.1 wifi repeater setup, you need a smart gadget. Now either with the help of default information which is written on the product label connect the gadget to the extender’s network. Or for hassle-free and direct connectivity directly use an ethernet wire. 

After a successful connection, open any internet browser. For eg: you can launch internet explorer, google chrome, firefox, safari or edge as well. Now as you open the browser, move to its address field. In it carefully pitch in the default IP address which is 192.168.10.1. Now press the enter key. In case the address doesn’t open up the window, then access it by using http://waplogin.link. 

Finally as you get an entry into the 192.168.10.1 wifi repeater setup page, give in the information that includes your current wifi network name and its password. Now the scanning will begin and you’ll get connected.

Lastly, unplug the extender and reposition it into a location where you need extended coverage. Be mindful that there shouldn’t be an excessive gap between the host router and the wifi repeater. For better performance place it halfway from the host router and the area with connectivity issues.