Easy Installation Guide For Wavlink Routers

Want to learn about the Wavlink router setup process? Here is the complete guide on the same.

Hardware Connections

First power on the modem. Next with the help of an Ethernet cable join the Wavlink router and the modem. Tie one part of the Ethernet cable to the WAN port of the router and the other end goes into the LAN port of the modem. Further, plug the power adapter’s pin into the power port of the router and then connect the power adapter to the electrical switch board. Switch on the entire setup and wait for it to boot up, so that you can pursue the installation steps.

Installation Steps

The Wavlink Router Setup process is quite easy and straightforward, all thanks to the user-friendly web interface.

• For installation, first select any smart device, preferably go with the computer system.
• Next, connect the device to the Wavlink router. For this you can use two alternative options.
• To connect wirelessly select the wifi network name which looks something similar to “ Wavlink-XXX”.
• Furthermore, for wired connection use properly working Ethernet cable.
• Now visit the address bar of your web browser and type the default IP address or web address. The IP address is http://192.168.10.1 whereas the default web address is http://wifi.wavlink.com for Wavlink routers.
• For Wavlink Router Setup it is important to login. So on the login page use the default security key (password) which is set to “admin”.

Complete The Setup

Finally, to complete the Wavlink Router Setup, first select the WAN connection type and tap on “Apply”. Lastly, carefully follow the on-screen instructions to successfully establish the network. Now, it’s time to connect your devices and check the connection by strolling around the different areas of your place.

Setup Failed? Follow These Steps!

Do not worry, if the Wavlink Router Setup fails, as there can be many reasons for the same. Try to resolve them through the below mentioned steps:

• First recheck all the wires that are connected to the router, modem and the host device.
• Next, ensure proper power supply for both modem and the Wavlink router. Preferably use the power plugs that are connected directly to the inverter. As it ensures constant and uncut power supply.
• Try to access the router’s web page through a different internet browser. Additionally, before proceeding with the Wavlink router setup process, clear the browser cookies.
• Further, if you aren’t able to connect to the router’s wifi network, then restart the router as well as the host device.
• If you had previously changed the default password of your Wavlink router and now you do not remember it then you need to perform factory reset.

To reset the Wavlink router, make sure it is turned on. Now, use the paperclip, with the help of it push down the reset button. Hold it until the router’s power light dozes off completely and then release the button. Finally, you can now use the default password to complete the setup or for logging in. You can now easily restart the Wavlink router setup process.