Wish to boost your home network setup? Don’t want to replace your existing router device but desire to extend the coverage in a particular area? If yes then the Wavlink repeater device is the best option you have. This device has the capability to get connected with the router and boost the coverage. If you are one of those who are facing trouble in performing the setup of the device then you reach the right platform. Here you will get information on what exactly you need to do if your wavlink repeater setup fails. Before troubleshooting the issue it is very important to understand why it happened. Just check out the further given section to know everything.
Common Reasons Behind Setup Fails
There are several reasons why you are experiencing wavelength repeater setup failures. Some of the reasons are specified here:
- Weak WiFi signal from the main router
- Incorrect WiFi password
- Improper repeater placement
- Browser cache preventing the setup page from loading
- Device not connected to the repeater’s network
- Outdated firmware
- Incorrect operating mode selection
If your device fails to connect because of any of the above given reasons then you can easily resolve the issue by following the below given tips.
How To Fix?
You can easily fix the issue by following the simple troubleshooting tips given below. These fixes will help you perform the setup without any trouble:
Verify The Power
First of all you need to verify that your device is powered on properly. There should be no damage to the power cable. If the power source is applied to stable power then you can proceed. If there is any issue then you have to change the power source.
Connect To Right Network
Make sure the device you are using to access the setup page is connected to the right network. You have to verify that the device is connected to the repeater network, not to any other network, not even with the main network.
Open Right Setup Page
You have to launch the browser to open the setup page using the accurate web address or IP address. If the paste doesn’t load then you have to clear the browser cache or try a different browser to access the page.
Select Right Mode
You need to verify that the device mode you have chosen to set up is accurate. If you choose the wrong mode then you will not be able to configure the device. When the screen will ask you to select more than you have to choose repeater mode for success.
Select The Right Host WiFi
You need to select the write network for connection. If you choose the wrong network then you will not be able to configure the device. While configuring make sure the device network you have chosen is the host router network.
Enter The Correct Information
Double check the router’s wireless network password while connecting the device to the network. If you enter wrong information then you will face trouble in connecting the devices.
Place The Device Properly
Poor placement of the device can also create trouble. You need to choose the best location for the setup. Initially try to place it close to the router device but not in corners or next to thick walls or closer to heavy metal objects.
Restart The Device
Restarting the device can resolve the temporary glitch. You have to restart your extender device by turning off the power supply and turning it on again after a while. This might resolve the problem.
Reset The Repeater
If the problem doesn’t resolve even after restart then you have to perform factory reset. Factory reset is the last option. This will erase the configuration and restore the default settings. To perform factory reset you have to push the reset button on the device.
Connect Us
Hope you are able to understand the above given troubleshooting and resolve the problem you are facing. But if not then don’t worry our technical experts are here to guide you. You can get their help by calling us on the below given number or dropping text in the life chat section. Our team will assist you with the right troubleshooting and performing the setup also. Don’t think too much, just dial!